A building is found to be losing heat to the outside during the winter months. Which would be the best solution to correct this design problem?


increase amount of heating

increase surface area of walls

increase number of windows

increase thickness of insulation




no link or I will report

Answer:

Why does Magnesium Oxide have a higher melting point than Sodium Chloride? ... As the charge in the ionic lattice in Magnesium Oxide is two times as large, the ionic bonding is stronger so more energy is required to overcome the electrostatic attraction and break down the ionic lattice.

HI thts way tooo much to answer but ye.

Answer:

1. Ag2CO3

2.Ba3(PO4)2

3. Cu(OH)2

4. AL

Explanation:

Answer:

Any change that increases the number of particles in a system increases entropy because it increases the randomness and disorder of the system.

Explanation:

Imagine dropping a glass pitcher on a hard surface. The pitcher breaks into numerous shards. If the shards were collected and dropped again, they would tend to break into smaller shards; they would not reassemble themselves into a pitcher. In the universe, there is a tendency for order to be replaced with disorder. This tendency is related to a concept called entropy. The formal definition of entropy is a measure of the degree of randomness and disorder in a system.

Answer:

iodine is 53

tellurium is 52

antimony is 51

Otin Is 50

Explanation:

Answer:

Explanation:

About 2,070 results (0.60 seconds)  

Answer is: at lower temperatures the reaction rate would decrease. The lower is the temperature, the slower the reaction becomes. ... Because this is exothermic reaction (enthalpy is less than zero), at lower temperatures, the equilibrium is in favor of ammonia, but the reaction doesn't proceed at a detectable rate.

Hi,

let us go through the question again

N2 + 3H2 ⇌ 2NH3 + energy  

Explain the problem surrounding the ammonia-making process in terms of chemical equilibrium.

So I would approach this question on the basis of effect of each of the reactants and products concentration on the equilibrium synthesis of ammonia.

If the concentration of any reactant is increased, the yield of ammonia is increased.

If the concentration of ammonia is reduced by removing it as it forms, the yield will as well be increased.

This reaction also yields heat meaning it is an exothermic reaction, so when we increase the temperature, the yield will be reduced. Hence it is favored by low temperature.

Answer:c

Explanation:

Answer:its c and d

Explanation:

Answer:

The enthalpy of an endothermic reaction is positive, I believe.

''The enthalpy of an endothermic reaction is positive'' is the true statement about endothermic reaction

If a reaction absorbs more energy than releasing it, the reaction is considered as endothermic and enthalpy will be positive while on the other hand, if a reaction absorbs less energy and releasing more, the reaction is considered as exothermic and enthalpy will be negative.

So we can conclude that option C is the right answer.

Learn more about reaction here: https://brainly.com/question/26018275

When a reaction has reached equilibrium with a given set of conditions, if the conditions are not changed, the reaction will remain at equilibrium forever. The forward and reverse reactions continue at the same equal and opposite rates and the macroscopic properties remain constant.

It is possible, however, to disturb that equilibrium by changing conditions. For example, you could increase the concentration of one of the products, or decrease the concentration of one of the reactants, or change the temperature. When a change of this type is made within a reaction at equilibrium, the reaction is no longer in equilibrium. When you alter something in a reaction at equilibrium, chemists say that you put stress on the equilibrium. When this occurs, the reaction will no longer be in equilibrium and the reaction itself will begin changing the concentrations of reactants and products until the reaction comes to a new position of equilibrium. How a reaction will change when a stress is applied can be explained and predicted. That is the topic of this section.

Answer:

i.e. mass of 1 mole of glucose, C6H12O6 = (6 × 12.01 + 12 × 1.01 + 6 × 16.00) g = 180.18 g (using atomic weight data to 2 decimals) 1 mole of carbon atoms weighs 12.01 g and there are 6 moles of C atoms in 1 mole of glucose, so the mass of carbon in 1 mole of glucose = 6 × 12.01 g = 72.06 g.

Answer:

A. The specific orbital within a sublevel

Explanation:

the third quantum number is also called the magnetic quantum number ([tex]m_{l}[/tex]) and it represents the number of orbitals within a subshell.

The atomic number or proton number (symbol Z) of a chemical element is the number of protons found in the nucleus of every atom of that element. The atomic number uniquely identifies a chemical element. It is identical to the charge number of the nucleus. In an uncharged atom, the atomic number is also equal to the number of electrons.

Answer:

its basically represents the number of protons in the nucleus which in a neutral atom equals the number of electrons outside the nucleus and that determines the place of the element in the periodic table

Explanation:

sry i its too long

hope it helps

Answer:

For example, when atoms lose or gain electrons they become charged particles called ions. Three ways electrons can be transferred are conduction, friction, and polarization. In each case, the total charge remains the same. This is the law of conservation of charge.

Explanation:

Answer:

Photosynthesis is the process takes place in green plants in which the plants convert the carbon dioxide and water into the sugar molecule and oxygen in presence of the sunlight. The sunlight is trapped by the chlorophyll pigment, carbon dioxide uptake is facilitated by the stomata present on the leaves in the epidermis.

The water moves from the roots to the leaves and stem where it is used for photosynthesis and transpiration. The movement of water is through the xylem and sugar is move through the phloem from the leaves to a different part of the plant for nutrition and further process.

Answer:

Explanation:

Even if you have a Hotmail email address, you now use the Outlook.com interface to ... I searched and found a Hotmail support number, but is it legit? ... one from Leo's e-mail, I receive a message from windows stating it can't find the site.

Answer:

Explanation:

u need to go to the Greenhouse Effect Simulation (link is in ur Q).

open it and select the Greenhouse effect tab.  Note that the concentration of various atmospheric gases during past eras can be determined by looking at gases trapped in ancient ice, such as that found in Antarctica.

On the right hand side panel of the simulation, under “Atmosphere during,” you can select Today, 1750, and Ice Age as historic time periods.

run simulations n collect the gas composition data.

Answer:

Explanation:

The question provides a link to the Greenhouse Effect Simulation. Results are from that:

Time Period         H2O %RH     CO2 ppm      CH4 ppm           N2O ppm

Today 58F            70%                338ppm       1843ppm             0.317ppm

1750 58F              70%                 280ppm      0.730ppm            0.270ppm

Ice Age 36F          ?                      180ppm       380ppm               0.215ppm

Answer:

94.196 grams

Explanation:

Answer:

94.196 grams

Explanation:

Answer:

Because of the gravity of the Earth

Answer:

V = 0.798 L

Explanation:

Hello there!

In this case, for this gas stoichiometry problem, we first need to compute the moles of carbon dioxide via stoichiometry and the molar mass of starting calcium carbonate:

[tex]3.56gCaCO_3*\frac{1molCaCO_3}{100gCaCO_3} *\frac{1molCO_2}{1molCaCO_3} =0.0356molCO_2[/tex]

Next, we use the ideal gas equation for computing the volume, by bearing to mind that the STP conditions stand for a pressure of 1 atm and a temperature of 273.15 K:

[tex]PV=nRT\\\\V=\frac{nRT}{P}\\\\V=\frac{0.0356mol*0.08206\frac{atm*L}{mol*K}*273.15K}{1atm} \\\\V=0.798L[/tex]

Best regards!

Answer:

the answer is destructive interference

Answer:

b

both objects will receive a certain amount of thermal energy and heat up

Answer:

Insulator

Explanation:

An eraser can't conduct electricity, which makes it an insulator.

Answer: C) the rate of forward reaction is not equal to the rate of backward reaction. This should be the answer.

Explanation:

Answer:

1. B = 1.13M

2. A. 8.46%

3. D = 0.0199

Explanation:

1. Molarity of a a solution = number of moles of solute/ volume of solution in L

Number of moles of solute = mass of solute/molar mass of solute

Molar mass of NaC₂H₃O₂ = 82 g/mol, mass of NaC₂H₃O₂ = 245 g

Number of moles of NaC₂H₃O₂ = 245 g / 82 g/mol = 2.988 moles

Molarity of solution = 2.988 mols/ 2.65 L = 1.13 M

2. Percentage by mass of a substance = mass of substance /mass of solution × 100%

Mass of 2.65 L of water = density × volume

Density of water = 1 Kg/L = 1000 g/L; volume of waterb= 2.65 L

Mass of water = 1000 g/L × 2.65 L = 2650 g

Mass of solution = mass of water + mass of solute = 245 + 2650 =2895 g

Percentage by mass of NaC₂H₃O₂ = 245/2895 × 100% = 8.46%

3. Mole fraction of NaC₂H₃O₂ = moles of NaC₂H₃O₂/moles of solution

Moles of water = mass /molar mass

Mass of water = 2650 g; molar mass of water = 18 g/mol

Moles of water = 2650 g / 18 g/mol = 147.222 moles

Moles of solution = moles of solute + moles of water = 147.222 + 2.988 = 150.21

Moles of NaC₂H₃O₂ =2.988 moles

Moles fraction of NaC₂H₃O₂ =2.988/150.21 = 0.0199

Answer:

[tex]m_{CO_2}=0.88g[/tex]

Explanation:

Hello there!

In this case, since we are talking about a decomposition reaction whereby calcium carbonate is decomposed to calcium oxide and carbon dioxide according to the following chemical equation:

[tex]CaCO_3\rightarrow CaO+CO_2[/tex]

Next, we must recall the law of conservation of mass which states that matter cannot be neither created nor destroyed so the mass of calcium carbonate equal the addition of the mass of both calcium oxide and carbon dioxide:

[tex]m_{CaCO_3}=m_{CaO}+m_{CO_2}[/tex]

Which must be solved for the mass of carbon dioxide as we are given those of calcium carbonate and calcium oxide:

[tex]m_{CO_2}=m_{CaCO_3}-m_{CaO}\\\\m_{CO_2}=2.00g-1.12g\\\\m_{CO_2}=0.88g[/tex]

Best regards!

Answer:

38.75 L

Explanation:

From the question,

Applying Boyles Law,

PV = P'V'....................... Equation 1

Where P = Original pressure of the Argon gas, V = Original Volume of Argon gas, P' = Final pressure of Argon gas, V' =  Final Volume of Argon gas.

make V the subject of the equation

V = P'V'/P.................... Equation 2

Given: P = 34.6 atm, V' = 456 L, P' = 2.94 atm.

Substitute these values into equation 2

V = (456×2.94)/34.6

V = 38.75 L

Answer:

h

Explanation:

gy

Answer:

substitutions, deletions and insertions

Answer:

the molecular formula of the soap is C₅₄H₁₀₂O₆

Explanation:

Given;

composition of carbon, C = 76.5%

composition of oxygen, O = 11.3%

Composition of hydrogen, H = 12.2%

The empirical formula is calculated as follows;

C:    76.5% / 12          O:  11.3% / 16             H:   12.2% / 1

     =  6.375                  =   0.706                   =  12.2

Divide through by the least number (0.706);

    =  6.375/0.706           = 0.706 / 0.706          =  12.2 / 0.706

   =  9                              =    1                              =  17

The empirical formula = C₉H₁₇O

The molecular formula is calculated as follows;

(C₉H₁₇O)n = 847

(9 x 12    +   17 x 1      +  16 x 1)n   = 847

(108 + 17 + 16)n = 847

141n = 847

n = 847/141

n = 6

The molecular is (C₉H₁₇O)6 =  C₅₄H₁₀₂O₆

Therefore, the molecular formula of the soap is C₅₄H₁₀₂O₆