Explain why the coin is able to float on top of the water in this glass.

Answer:

Explanation:

55m/s

The magnitude of velocity in east direction will be 650 N approximately.

What is velocity ?

velocity is given by the change in distance by the object with respect to change in time. It is a vector quantity and having S.I unit as m/s.

Here it is given that magnitude of velocity is 750 N and making an angle of 30 degree with x axis in counterclockwise direction as shown in figure below :

Now resolving and writing magnitude of velocity V in x and y direction respectively :

[tex]\begin{aligned}Vcos\theta&= 750 cos30^{o}=650 \:m/s\\Vsin\theta&= 750sin30^{o}= 375 m/s\end{aligned}[/tex]

It should be noted that [tex]vsin\theta[/tex] is acting in negative y direction.

Therefore, the magnitude of velocity in east direction is 650 m/s

check and know more about velocity here :

https://brainly.com/question/13563520

#SPJ2

Answer:

I need the picture to amswer the question thay's why it says " "

Using the information depicted on the distance - time graph, the slope of the graph is could be used to infer the velocity of each cyclist. Hence, cyclist A and B do not have the same velocity at 3 seconds.

The steepness of slope on the distance - time graph gives the velocity of the cyclist. At time, t = 0 ; the cyclist A has a greater slope than cyclist B. Hence, the velocity of the cyclists is different.

Therefore, the cyclists do not have the same velocity at time, t = 3 seconds.

Learn more : https://brainly.com/question/25220539

The force of static friction acting on  the box is greater than the applied horizontal force.

Force is known to be the reason for motion according to Newton's first law of motion. An object will move when it has been acted upon by an external force.

In this case, a box lying on a table has been acted upon by an external force of  12 newton but the box remains at rest. This simply means that the applied force is less than the force of static friction acting on  the box.

Learn more about motion: https://brainly.com/question/8898885

Answer:

gravity

Explanation:

because it acts on a particular direction that is towards the ground

brainliest plz

Answer: Because it can dissolve in water

Explanation: Logic

Answer:

what are you trying to do for this question

Explanation:

Answer:

450cm = 4.5m

24miles = 3862430 cm (3.9×10⁶cm)

16.7 gallons = 63.216 liters (approx.)

Explanation:

brainliest plz

Answer:C (198 seconds)

Explanation: The cyclist makes the first lap in (180.00 - 6.00) = 174.00 seconds. The average time per lap for all three circuits is (600.00 - 6.00) = 594/3 = 198 seconds.

Answer:

False is the correct answer.

It is considered more of a chemical change because all of the cells inside the plant decompose (change chemicaly)

Answer:

False

Explanation:

saw this on another brainly question, it's because a flower that becomes a poisonous flower would be a chemical change. If it were to mix with the poison it would just become something new entirely.

Answer: Action-Reaction force pairs

Explanation: please make me brainiest thanks

Answer:

"action-reaction force pairs"

Explanation:

...

Answer:

5 years[tex][/tex]

Answer:

Tu mujhe banaye ga face dekh aapna mirror me

Answer:

iloveyouuuuuuuuuuuuuuu

Answer:

Vf = 23 m/s

Explanation:

First we need to find the distance covered by the motorcycle 2 when it passes motorcycle 1. Using the uniform speed equation for motorcycle 1:

s₁ = v₁t₁

where,

s₁ = distance covered by motorcycle 1 = ?

v₁ = speed of motorcycle 1 = 6.5 m/s

t₁ = time = 10 s

Therefore,

s₁ = (6.5 m/s)(10 s)

s₁ = 65 m

Now, for the distance covered by motorcycle 2 at the meeting point. Since, the motorcycle started 50 m ahead of motorcycle 2. Therefore,

s₂ = s₁ + 50 m

s₂ = 65 m + 50 m

s₂ = 115 m

Now, using second equation of motion for motorcycle 2:

s₂ = Vi t + (1/2)at²

where,

Vi = initial velocity of motorcycle 2 = 0 m/s

Therefore,

115 m = (0 m/s)(10 s) + (1/2)(a)(10 s)²

a = 230 m/100 s²

a = 2.3 m/s²

Now, using 1st equation of motion:

Vf = Vi + at

Vf = 0 m/s + (2.3 m/s²)(10 s)

Vf = 23 m/s

The second stone hits the ground exactly one second after the first.

The distance traveled by each stone down the cliff is calculated using second kinematic equation;

[tex]h = v_0_yt + \frac{1}{2} gt^2[/tex]

where;

[tex]h = \frac{1}{2} gt^2[/tex]

The time taken by the first stone to hit the ground is calculated as;

[tex]t_1 = \sqrt{\frac{2h}{g} }[/tex]

When compared to the first stone, the time taken by the second stone to hit the ground after 1 second it was released is calculated as

[tex]t_2 = \sqrt{\frac{2h}{g} } + 1[/tex]

[tex]t_2 = t_1 + 1[/tex]

Thus, we can conclude that the second stone hits the ground exactly one second after the first.

"Your question is not complete, it seems be missing the following information;"

A. The second stone hits the ground exactly one second after the first.

B. The second stone hits the ground less than one second after the first

C. The second stone hits the ground more than one second after the first.

D. The second stone hits the ground at the same time as the first.

Learn more here:https://brainly.com/question/16793944

Answer:

Objective Lenses: Usually you find 3 or 4 objective lenses on a microscope. They almost always consist of 4x, 10x, 40x and 100x powers, when coupled with a 10x (most common) eyepiece lens, total magnification is 40x (4x times 10x) 100x, 400x and 1000x

Explanation:

Objective lenses come in various magnification powers, with the most common being 4x, 10x, 40x, and 100x, also known as scanning, low power, high power and typically oil immersion objectives, respectively

[tex]\\ \sf\longmapsto I=\dfrac{Q}{t}[/tex]

[tex]\\ \sf\longmapsto Q=It[/tex]

[tex]\\ \sf\longmapsto Q=0.0016(3600)[/tex]

[tex]\\ \sf\longmapsto Q=5.76C[/tex]

Explanation:

An analog signal has some feature that is a continuous function of the program material being transmitted. It may take on any of a range of values.

In radio, amplitude, frequency, or phase are features of the radio signal commonly modulated when transmitting an analog signal.

__

A digital signal has some feature that is a discrete function of the program material being transmitted. It may take on any of a specific set of values.

A digital radio signal typically uses some combination of amplitude, frequency, and phase to represent a discrete state being transmitted. Only specific values of these are used by the transmitter.

(The receiver generally has to deal with corruption of the signal by the transmission channel, so the received set of values may not correlate well with those intended at the transmitter. This is why error-correcting codes are often used with digital signal transmission.)

_____

Additional comment

Analog radio signals are generally transmitted using a carrier wave at a specific frequency (or in some specific frequency range, in the case of frequency modulation). Processing techniques may be used at the transmitter to limit the bandwidth used in the transmission. One commonly-used technique is to limit the transmitted spectrum to one side of the carrier wave frequency. (This is called "single side-band" radio.)

Digital signals offer the opportunity to transmit different bits of the information at different frequencies. Sometimes, "frequency hopping" is used, so that the transmitted carrier wave jumps around from one frequency to another in a predetermined pattern. The effect of this is to spread out the spectrum of the transmitted signal so that average power in any frequency band is significantly reduced. In fact, it may be indistinguishable from background noise, except by a receiver that tunes to the carrier wave in the predetermined frequency pattern.

[tex]\huge\fbox\orange{A} \huge\fbox\red{N}\huge\fbox\blue{S}\huge\fbox\green{W}\huge\fbox\gray{E}\huge\fbox\purple{R}[/tex]

[tex]\huge\underline\mathtt\colorbox{cyan}{For Positively Charged:}[/tex]

By gaining electrons from the ground, the object will have a balance of charge and therefore be neutral. Grounding is the grounding of a positively charged object and involves the transfer of electrons from the ground into the object.

[tex]\huge\underline\mathtt\colorbox{red}{For Negatively Charged:}[/tex]

If it is to have its charge removed, then it will have to lose its excess electrons. Once the excess electrons are removed from the object, there will be equal numbers of protons and electrons within the object and it will have a balance of charge.

Answer:

[tex]( \nwarrow^{ + }) \sum \: F_{{y_{A}}_{2kg}} = F_{{y_{N_A}}_{2kg}} - m_{{y_{A}}_{2kg}}g \cos( \theta_{{y_{A}}_{2kg}}) = 0 \\ F_{{y_{N_A}}_{2kg}} = m_{{y_{A}}_{2kg}}g \cos( \theta_{{y_{A}}_{2kg}})...(1) \\ ( \nearrow^{ + }) \sum \: F_{{x_{A}}_{2kg}} = F_{{x_{T}}} - m_{{y_{A}}_{2kg}}g \sin( \theta_{{y_{A}}_{2kg}}) -F_{{Fr}_{A2kg}}= m_{{y_{A}}_{2kg}}a...(2) \\ \\ ( \nearrow^{ + }) \sum \: F_{{y_{B}}_{5kg}} = F_{{y_{N_B}}_{2kg}} - m_{{y_{B}}_{5kg}}g \cos( \theta_{{y_{B}}_{5kg}}) = 0 \\ F_{{y_{N_B}}_{5kg}} = m_{{y_{B}}_{5kg}}g \cos( \theta_{{y_{B}}_{5kg}})...(3) \\ ( \searrow^{ + }) \sum \: F_{{x_{B}}_{5kg}} = m_{{y_{B}}_{5kg}}g \sin( \theta_{{y_{B}}_{5kg}})-F_{{x_{T}}} -F_{{Fr}_{B5kg}}= m_{{y_{B}}_{5kg}}a...(4)[/tex]

Explanation:

All you need to do is plug in the values and solve the simultaneous equations to find the acceleration a, and T.

Always draw the free body diagram...

Answer:

225cos30

Explanation:

Force in the direction of the work done

Answer:

c. changes can occur to certain physical properties

Explanation:

got it right on test

Answer:

1. The efficiency of the induction increases when the mechanical load increases because as the motors load increases, its slip increases, and the rotor speed falls. Since the rotor speed is slower, there is more relative motion between the rotor and the stator magnetic fields in the machine.

Explanation:

Answer:

They can help us in our daily lives

Explanation:

I knew that they can also be a help to others specially in other ways such as to help us to facilitate our work in home

Answer:

This is Newton’s third law (forces due to friction). There would be 15N being pushed back at Jane.

Explanation:

Newton’s third law states that for every action there is an equal and opposite reaction. So if Jane pushed with a force of 15N, 15N would be pushed back at her. Hope this helps! :)

Answer:

Smaller forces are easier on your legs and you prefer to land on soft grass. Momentum/impulse explanation: Whether you land on concrete or soft grass, your change in momentum will be identical. A hard surface that brings you to a stop in 0.01 s requires a much larger force of 15,000 N.

Explanation:

Answer:

19.4Nm..............