Answer:
because the knife is sharp
Answer:
Pressure is inversely proportional to the area of the surface. While a blunt knife has more area coming in contact than a sharp knife and the pressure exerted by the blunt knife will be less as compared to that of a sharp knife. Therefore it is easier to cut with a sharp knife.
Explanation:
Hope this helps! mark as brainliest please...
why do the lights in your home come on almost instantaneously when you turn on the switch?
Answer:
here you go
Explanation:
Why do your lights actually come on almost instantaneously? ... Wiring the house in parallel does not make a difference – there is no current flowing through the light bulb when the switch is off no matter how the house is wired. If there were a current already, the light would be on!
the quantity x to be determined from the equation X=P-Q.
Answer:
the correct answer will be 6.82 %that is 7%
p(1.27)-q(0.83) =x=0.44
0.02+0.01 =0.03 (maximum uncertainty)
percentage uncertainty =0.03/0.44×100 %
=6.82%
=7%
Explanation: it was d on my end
How could you set up the Strong and Weak magnets to show Barry that strong magnets and weak magnets can BOTH repel and attract object's?
Answer:
To show that magnets repel, you must place the strong and weak magnets to another magnet with their poles being both south or both north facing eachother.
To show they attract, place opposite poles near eachother.
Hãy giải đề giúp tui
Answer:
ở đâu?
Explanation:
................
The Sun being the largest body has the highest gravitational pull on all planets however planets do not collapse into the sun this is because of A.gravitational I'll of the Earth B. gravitational pull among the planets C. gravitational pull of Moon D. the balancing force
Answer:
A:gravitational of the earth
Fuzzy and kermit
are driving at 10 m/s but slow down to meters per seconto avoid hitting a squirrel a time it takes in a slow down is 3.1 seconds what is the acceleration
Answer:
-2.9m/s[tex] { - 2.9ms}^{2} [/tex]As shown above an adhesive has been applied to contacting faces of two blocks so that the blocks interact with an adhesive force that has a magnitude, Fadhesion A tension, T, is exerted by a wire attached to the upper blocks causing the blocks to remain at rest The two blocks have weights, Wbottom and Wtop. Which of the following must be true? (1 point) ♡ O Wtop=T OT = Wtop - Fadhesion O Wbottom Fadhesion O T = Wbottom + Wtop + Fadhesion
The magnitude of the adhesive force allows the top block to remain
attached to the bottom when the blocks and the wire are balanced.
The option that must be true is; [tex]\mathbf{W_{bottom} = F_{adhesion}}[/tex]
Reason:
The tension exerted by the wire attached to the top block = T
Magnitude of the adhesive = [tex]F_{adhesion}[/tex]
Weight of the top block = [tex]W_{top}[/tex]
Weight of the bottom block = [tex]W_{bottom}[/tex]
Given that with the exertion of the tension, the two blocks remain at rest, we have;
T = [tex]W_{top}[/tex] + [tex]W_{bottom}[/tex]The adhesive causes the bottom block to remain attached to the top block, we have;
Therefore, the magnitude of the adhesive force adds the bottom weight, to the top, weight, which gives;
The magnitude of the adhesive force = The weight of the bottom block
Therefore;
[tex]W_{bottom}[/tex] = [tex]F_{adhesion}[/tex]Learn more here:
https://brainly.com/question/18907970
Answer:
Wbottom=Fadhersion it was right on y test
Explanation:
Công của lực điện không phụ thuộc vào?
Explanation:
what language is thathow do I literally understand thata tennis ball is launched from the floor at a velocity of 90 m/a at an angle of 13 degrees to the horizontal. calculate its range
Answer:
~186
Explanation:
1) R= (V^2 × sin A ) /g
V=90 m/a
A= 13°
g= 9.8 or 10 (I will take 9.8 for right result)
R= (90^2 × sin 13) / 9.8 = 185.928932672 ~ 186
Political polls taken before major elections are examples of ________ research.
Answer:
survey
Example:
none
Using your knowledge of momentum explain why cars are designed to have crumple zones?
Answer: I think cars are designed to have crumble zone because lets say you're going 60-70 mph and you hit a brick wall that cant move, it would be a very hard jolt causing the beings inside to get thrown forward, but if it has a crumble zone it would slow the the jolt from is slowing down in the hit.
Pendulum mass is 4 kg. Use your equations for gravitational potential energy and kinetic energy to determine these values based on the data given below. Total energy is the sum of gravitational potential energy and kinetic energy. In this problem, round gravity to: g = 10 m/s2.
its should be 2.0 and 4.5 on it
how much is a city of a body when it covers 600m in 5 min?
it is an answer : 2 m/s
i don't know sloution
Answer:
2m/s
Explanation:
5min × 60sec
=300
now,
600÷300
=2
Friction can be reduced by using ___________.
Answer:
Make the surfaces little more smoother. ...
Lubrication is another way to make a surface smoother. ...
Make the object more streamlined. ...
Reduce the Normal force acting between the surfaces in contact. ...
Reduce the contact between the surfaces, so that less number of bonds will be formed.
in 10 seconds a car accelerates 4m/s^2 to 50
m/s. How fast was the car going before it accelerated?
Variables:
Equation and Solve:
Answer:
10m/s
Explanation:
using the formula a=v-u
t
What is an inclined plane that is wrapped in spiral
Answer:
A screw
Explanation:
The threads of a screw act like an inclined plane to increase the distance over which you exert the input force.
A projectile is shot from the edge of a cliff 125 m above the ground level with an initial speed of 105 m/s at an angle of 37 degrees with the horizontal. (a) Determine the vertical velocity final. (it is not - vi, since we are on a cliff 125m up)
A.)80.2 m/s
B.)-80.2 m/s
C.)40.2 m/s
D.)-40. 2 m/s
Answer:
alright we have to find the initial velocity of the projectile which was shot from the edge of a cliff 125m above ground level with the initial speed being equivalent to 105 m/s at an angle of 37 degrees i would assume the answer to be C. hope this helps im a tad rusty at this subject
Explanation:
I WILL CROWN THE BRAINLIEST IF YOU ANSWER CORRECT
ELECTROMAGNET WAVES
Travel through what?
Carry energy, often called what?
Emitted by what?
Three Examples of electromagnetic waves.
Answer:
Electromagnetic waves differ from mechanical waves in that they do not require a medium to propagate. This means that electromagnetic waves can travel not only through air and solid materials, but also through the vacuum of space.
Example: Radio waves, microwaves, visible light, and x rays
Scientists can determine a fossil's actual age by using which of the following methods?
hypothesizing
relative dating
radiometric dating
estimation
I NEED THIS ANSWERED ASAP NO LINKS !!!
I need a answer that is 100% ACCURATE
Answer:
it increasees
Explanation:
its 100% acurate dont worry
Two waves travel through ocean, one with wavelength 3 m, one with 6 m. Which one has greater speed?
Answer: 6m
Explanation: 6 is more than 3 and their both being measured by m
a car travels west for 240km in 4 hr what is the car velcity
what is the energy of light for a single photon that has a wavelength of 347 nm?
The energy of light for a single photon that has a wavelength of 347 nm is 5.698 × 10-¹⁹ J
HOW TO CALCULATE ENERGY:
The energy of a photon of light can be calculated by using the following formula:E = hf
Where;
E = energy of photon (J)h = Planck's constant (6.626 × 10-³⁴J/s)f = frequency (Hz)However, the frequency must first be calculated using the formula as follows:λ = v/f
Where;
λ = wavelengthv = speed of light (3 × 10⁸m/s)f = frequencyf = v ÷ λf = 3 × 10⁸ ÷ 347 × 10-⁹f = 3/347 × 10⁸+⁹f = 0.0086 × 10¹⁷ Hzf = 8.6 × 10¹⁴ HzE = 6.626 × 10-³⁴ × 8.6 × 10¹⁴E = 56.98 × 10-²⁰E = 5.698 × 10-¹⁹ JTherefore, the energy of light for a single photon that has a wavelength of 347 nm is 5.698 × 10-¹⁹ J.Learn more at: https://brainly.com/question/13407202?referrer=searchResults
A 30N force is applied to an object having a mass of 300 grams. Calculate the acceleration of the moving object
Answer:
9000 m/s
Explanation:
A=Fm
Acceleration = Force x Mass(Newtons)
Q1. A 130 N horizontal force keeps a 30 kg chair moving at a constant velocity. Find the
coefficient of kinetic friction between the chair and the floor.
The coefficient of kinetic friction between the chair and the floor is 0.442.
The given parameters;
horizontal force on the chair, F = 130 Nmass of the chair, m = 30 kgThe normal force on the chair is calculated as follows;
Fₙ = mg
Fₙ = 30 x 9.8 = 294 N
The frictional force between the chair and the floor is calculated as follows;
Fk = μFₙ
The net force on the chair is calculated as follows;
[tex]\Sigma F_x = 0\\\\F- \mu_k F_n = 0\\\\130 - \mu_k (294) = 0\\\\\mu_k = \frac{130}{294} \\\\\mu_k = 0.442[/tex]
Thus, the coefficient of kinetic friction between the chair and the floor is 0.442.
Learn more here:https://brainly.com/question/20241845
Distance between gas molecules in the case of:
-Increase in temperature
-Decrease in temperature
-Increase in volume
-Decrease in volume
-Increase in pressure
-Decrease in pressure
Answer:
-Increase in temperature: increase
-Decrease in temperature: decrease
-Increase in volume: increase
-Decrease in volume: decrease
-Increase in pressure: increase
-Decrease in pressure: decrease
Explanation:
-Increase in temperature:
● Molecules gain kinetic energy and move fast thus increasing distance
-Decrease in temperature:
● Kinetic energy of molecules decrease so they have smaller distance
-Increase in volume:
● Molecules have more space to move around so distance increase
-Decrease in volume:
● Less space, molecules collide with each other because of decreased distance thus increasing pressure
-Increase in pressure
● Molecules collide with each other and the walls of container increasing pressure so molecules move faster and it increases distance
-Decrease in pressure:
● Molecules collide with each other and walls of container less frequently so distance between molecules decrease
an object at rest has no ________ energy, but it may have ________ energy resulting from its location or structure.
Answer: first blank: kinetic
Second blank: potential
Explanation:
Hope this helps and please consider choosing me for Brainiest!
Describe the difference between distance, position, and displacement
Answer:
Explanation:
Position is the location of the object (whether it's a person, a ball, or a particle) at a given moment in time.
Displacement is the difference in the object's position from one time to another.
Distance is the total amount the object has traveled in a certain period of time.
I hope this helps!
An object is travelling at a velocity of 5m/s to the right for 5 seconds. If NO forces are applied to the object, what will the velocity of the object be after 5 seconds.
Answer:
Below
Explanation:
We can use this formula to find the final velocity of the object :
vf = vi + at
Now, because no force is applied to the object, the acceleration of this object will be 0 according to Newton's 1st law!
vf = 5m/s + (0)(5)
vf = 5 m/s
Hope this helps!
identify the types of elements in the schematic diagram give the number of each types
Where's the diagaram?