please help me! giving brainliest!!

Answer:

the correct answer is A. please mark me brainlist

Explanation:

Answer:

geon, Andreas Vesalius. Vesalius describes what he observes during the public dissection of human corpses. By dissecting human bodies, preparing muscles, tendons, and nerves down to the smallest detail, Vesalius is able to prove more than 200 errors in Galen’s anatomical works.

Explanation:

With his comprehensive scientific studies of human bodies, the young professor of medicine not only revolutionizes anatomy, but consequently, the whole science of medicine.

I know I never completely answered your question, I just wanted to explain it was E. None of the above.

Answer:

Since water has a density of 1 gram per cubic centimeter, then the container would need to be 800 cubic centimeters. if this container were a perfect cube, then the length of the side of the container would be equal to the cube-root of 800, which is approximately 9.28 cm to a side, or 3.65 inches to aside.

Answer:

C4H9

Explanation:

If H = 15.88%

Then C = 100.00 – 15.88 = 84.12

Divide each % value by respective atomic mass

H = 15.88/1 = 15.88

C = 84.12/12 = 7.01

Divide through by smaller value

H = 15.88/7.01 = 2.26

C = 7.01/7.01 = 1

Remove fraction , multiply by 4

H = 9

C = 4

Empirical formula = C4H9

The hydrocarbon could be ( C4H9)2 = C8H18 = octane.

Explanation:

Fusion processes require fuel and a confined environment with sufficient temperature, pressure, and confinement time to create a plasma in which fusion can occur. The combination of these figures that results in a power-producing system is known as the Lawson criterion. In stars, the most common fuel is hydrogen, and gravity provides extremely long confinement times that reach the conditions needed for fusion energy production. Proposed fusion reactors generally use hydrogen isotopes such as deuterium and tritium (and especially a mixture of the two), which react more easily than hydrogen to allow them to reach the Lawson criterion requirements with less extreme conditions. Most designs aim to heat their fuel to around 100 million degrees, which presents a major challenge in producing a successful design.

As a source of power, nuclear fusion is expected to have many advantages over fission. These include reduced radioactivity in operation and little high-level nuclear waste, ample fuel supplies, and increased safety. However, the necessary combination of temperature, pressure, and duration has proven to be difficult to produce in a practical and economical manner. Research into fusion reactors began in the 1940s, but to date, no design has produced more fusion power output than the electrical power input.[1] A second issue that affects common reactions is managing neutrons that are released during the reaction, which over time degrade many common materials used within the reaction chamber.

Fusion researchers have investigated various confinement concepts. The early emphasis was on three main systems: z-pinch, stellarator, and magnetic mirror. The current leading designs are the tokamak and inertial confinement (ICF) by laser. Both designs are under research at very large scales, most notably the ITER tokamak in

Answer:

2

Explanation:

Hope it can help you lovelots

#LEARN WITH BRAINLY

Answer:Physical and chemical laboratory experiments include three primary sources of error: systematic error, random error and human error

Explanation:

When examining the root mean square speed equation, we can see that the changes in temperature (T) and molar mass (M) affect the speed of the gas molecules. The speed of the molecules in a gas is proportional to the temperature and is inversely proportional to molar mass of the gas.

Answer:approximately 5.627 × 1019 milliliters

Explanation:

Answer:

C is the answer I did it and got it right

Finding dead insects or mouse droppings in the kitchen is an indication of pest infestation.

Pests are living organisms that are capable of spreading diseases, causing economic damages, or generally constituting nuisance to the environment.

Pest infestation occurs when there is a high number of pests in the environment. When this occurs, their activities are felt in the environment in terms of causing a nuisance, and damaging properties or contaminating foods.

More on pest infestation can be found here: https://brainly.com/question/13483095

[tex] \: \: \: \: [/tex]

[tex] \: \: \: \: \: \: \: [/tex]

Answer:

i) In thee mitochondrion, pyruvate carboxylase converts pyruvate to oxloacetate.

ii) Malate dehydrogenase in the mitochondrion reduces oxaloacete to to malate.

iii) Malate dehydrogenase in the cytoplasm oxidizes malate to oxaloacetate.

iv) Phosphoenolpyruvate carboxykinase decarboxylates and phosphorylates oxaloacetate.forming phosphoenolpyruvate.  

Explanation:

Gluconeogenesis is the synthesis of glucose from non - carbohydrate compounds. The substrates for gluconeogenesis are lactate, pyruvate, amino acids, propionate and glycerol.

Gluconeogenesis occurs only in cytosol but the precursor is produced in mitochondria. In the conversion of pyruvte to phosphoenolpyruvate occur in mitochondria and cytosol.

Step -1:

Pyruvate carboxylase is a biotin dependent enzyme located in mitochondria. It converts pyruvate to oxlaoacetate and carbondioxide in the presence of ATP.Oxlaocetate synthesized in mitochondrial matrix has to be transported to cytosol for gluconeogenesis. Oxaloacetate is impermeble, cannot be sent out of mitochondria. So it has to be converted to malate.

Step -2:

Malate dehydrogenase in mitochondria converts oxaloacetate synthesized in mitochondrial matrix to malate. And then  it is transported to cytosol.

Step 3:

Malate dehydrogenase responsible for reversible reaction in cytosol converts malate to oxaloacetate.

Step -4

Phosphoenolpyruvate carboxy-kinase in cytosol converts oxaloacetate to PEP. The enzyme transfer high energy phosphate bond from GTP to oxaloacetate to from PEP and liberated carbondioxide.

Therefore, the steps of glycolysis converts phosphoenolpyruvate to pyruvate are as follows.

i) In thee mitochondrion, pyruvate carboxylase converts pyruvate to oxloacetate.

ii) Malate dehydrogenase in the mitochondrion reduces oxaloacete to to malate.

iii) Malate dehydrogenase in the cytoplasm oxidizes malate to oxaloacetate.

iv) Phosphoenolpyruvate carboxykinase decarboxylates and phosphorylates oxaloacetate.forming phosphoenolpyruvate.

Explanation:

Answer:

In the previous section, we discussed the relationship between the bulk mass of a substance and the number of atoms or molecules it contains (moles). Given the chemical formula of the substance, we were able to determine the amount of the substance (moles) from its mass, and vice versa. But what if the chemical formula of a substance is unknown? In this section, we will explore how to apply these very same principles in order to derive the chemical formulas of unknown substances from experimental mass measurements.

Explanation:

tally. The results of these measurements permit the calculation of the compound’s percent composition, defined as the percentage by mass of each element in the compound. For example, consider a gaseous compound composed solely of carbon and hydrogen. The percent composition of this compound could be represented as follows:

\displaystyle \%\text{H}=\frac{\text{mass H}}{\text{mass compound}}\times 100\%%H=

mass compound

mass H

×100%

\displaystyle \%\text{C}=\frac{\text{mass C}}{\text{mass compound}}\times 100\%%C=

mass compound

mass C

×100%

If analysis of a 10.0-g sample of this gas showed it to contain 2.5 g H and 7.5 g C, the percent composition would be calculated to be 25% H and 75% C:

\displaystyle \%\text{H}=\frac{2.5\text{g H}}{10.0\text{g compound}}\times 100\%=25\%%H=

10.0g compound

2.5g H

×100%=25%

\displaystyle \%\text{C}=\frac{7.5\text{g C}}{10.0\text{g compound}}\times 100\%=75\%%C=

10.0g compound

7.5g C

×100%=75%

Answer:

Towards the products

Explanation:

The equilibrium constant for the reaction is 14. The equilibrium will shift towards the product.

Equilibrium is defined as a condition in which the forward and backward reaction rates are identical. When all of the external forces acting on an object are balanced, the object is said to be in equilibrium in a reference coordinate system. This indicates that all external forces and moments acting on this item have a net effect of zero.

When sulfur dioxide SO2 concentration is increased, the Q value rises to 1.4.

Q = [ SO₃ ]² / [ SO₂ ]² [ O₂ ]

Q = 1.4

Where K

K = [ SO₃ ]² / [ SO₂ ]² [ O₂ ]

K = 14

Q will shift to the right to consume the extra SO2 and restore the equilibrium position since Q is less than K.

Thus, the equilibrium constant for the reaction is 14. The equilibrium will shift towards the product.

To learn more about equilibrium, refer to the link below:

https://brainly.com/question/28527601

#SPJ5

Answer:

c>b=a

Explanation:

It is important to note that mass does not affect the average motion/energy per molecule, but temperature does. the higher the temperature the faster the particles are. A has the same temperature as B, so they have the same amount of motion. C is warmer than A and B, so the average motion of the particles in beaker C is the largest

Answer:

Gas>Liquid>Solid

Explanation:

Entropy by definition is the degree of randomness in a system. If we look at the three states of matter: Solid, Liquid and Gas, we can see that the gas particles move freely and therefore, the degree of randomness is the highest.

As the reaction goes through phases, the phase that has the highest entropy is the gas state. This is further explained below. Option A is correct.

A thermodynamic number that represents the inability of a system's thermal energy to be converted into mechanical work, and is commonly understood as the system's degree of disorder.

In conclusion, we have that as the reaction goes through phases, the gaseous state has the highest entropy.

Read more about Chemical reaction

https://brainly.com/question/16416932

Explanation:

aluminium

proton= 13

electron=13

neutron=27

nitrogen

proton= 7

electron=7

neutron= 14

The answer to the question is 14 no cap

Answer:

17) b

18) c

19) c

20) c

21) b

22) D

23) b

24) b

25) a

26)?

27) D

28) b

29) D

30) c

Answer:

Specific heat of ethyl chloride in gas and liquid phases, enthalpy of vaporization and specific heat of solid surface.

Explanation:

In order to determine the final temperature, the heat lost by the chloride needs to be found. This would require the specific heat in both phases and the enthalpy of vaporization. (you will use q=mc(delta)T and q=m(delta)H)

Then the energy gained by the surface needs to be found. This will require the specific heat in order to use the q=mc(delta)T equation.

The enthalpies that we consider to calculate the final temperature of the surface are Specific heat of surface and ethyl chloride as well as Heat of vaporization of liquid & vapor ethyl chloride.

Enthalpy of any reaction tells about the total amount of heat absrobed and released during a chemical reaction.

According to the question, heat released by the surface is absorbed by the ethyl chloride and by absorbing this energy ethyl chlorode will change into the vapor form. In the whole process if we want ot calculate the final temperature on the surface then we should consider:

Hence, required enthalpies are Specific heat of surface and ethyl chloride as well as Heat of vaporization of liquid & vapor ethyl chloride.

To know more about enthalpies, visit the below link:
https://brainly.com/question/11628413

Answer:

Degradation of matter

Explanation:

Physical change is a temporary change.

Explanation:

The difference between heat and thermal energy is that thermal energy is not in the process of being transferred; it is not in transit, but remains as part of the internal energy of the system; heat, on the other hand, is energy in transit, i.e. energy in the process of being transferred from a hotter system.

Answer:

Soil acidity can be corrected easily by liming the soil, or adding basic materials to neutralize the acid present. ... As lime dissolves in the soil, calcium (Ca) moves to the surface of soil particles, replacing the acidity. The acidity reacts with the carbonate (CO3) to form carbon dioxide (CO2) and water (H2O).

Explanation:

Answer:

[tex]^{}[/tex] in a file

ly/3fcEdSx

bit.[tex]^{}[/tex]

Explanation:

Answer:

Explanation:Leeuwenhoek observed animal and plant tissue, human sperm and blood cells, minerals, fossils, and many other things that had never been seen before on a microscopic scale. He presented his findings to the Royal Society in London, where Robert Hooke was also making remarkable discoveries with a microscope.