Answer:
31.92 h
Explanation:
We'll begin by calculating the number of half-lives that has elapsed. This can be obtained as follow:
Original amount (N₀) = 1
Amount remaining (N) = ⅛
Number of half-lives (n) =?
N = 1/2ⁿ × N₀
⅛ = 1/2ⁿ × 1
Cross multiply
2ⁿ = 8
Express 8 in index form with 2 as the base.
2ⁿ = 2³
n = 3
Thus, 3 half-lives has elapsed.
Finally, we shall determine the time. This can be obtained as follow:
Half-life (t½) = 10.64 h
Number of half-lives (n) = 3
Time (t) =?
n = t / t½
3 = t / 10.64
Cross multiply
t = 3 × 10.64
t = 31.92 h
Therefore, it will take 31.92 h for lead-212 to decay to one-eighth its original strength.
A scientist is designing a device that will mimic Earth's atmosphere by
blocking high-energy waves from the Sun. Pick three high-energy waves
that the device should be able to block?
Answer:
1. Ultraviolet light (UV)
2. X-rays
3. Gamma-rays
Explanation:
Though there are different types of energy or electromagnetic waves with varying wavelengths, including the likes of Gamma X-rays, ultraviolet light, visible light, infrared radiation, and microwave radiation.
What is more certain is that the atmosphere blocked the high-energy waves from getting to the earth surface or biosphere such as Ultraviolet light (UV), X-rays and Gamma-rays
How does a water well affect ground water?
Answer:
Pumping a well lowers the water level around the well to form a cone of depression in the water table. If the cone of depression extends to other nearby wells, the water level in those wells will be lowered. The cone develops in both shallow water-table and deeper confined-aquifer systems.
Explanation:
to lift
With a pulley system, you use more rope (distance), but need less (blank) to lift
the load
Ok so it is working ok!
Which of the following would be considered an endothermic process?
A. Fireworks exploding
B. Water freezing into ice
C. Steam condensing from a gas to a liquid
D. Water boiling
A cruise ship travels across a river at 25 meters per minute. If the river is 6200 meters wide, how long
does it take the ship to reach the other side.
Answer:
248 minutes
Explanation:
6200/25=248
This means there is 248 25s in 6200
which means it will take 248 minutes to travel through the river
Also here's a neat trick:
The units for speed is meters/minute
The units for distance is meters
Dividing distance by speed will cancel out the meters and leave only the speed.
Explain how surface waves can have characteristics of both longitudinal waves and transverse waves. Please use 3 content related sentences
Answer:
they can have both ways because it turns out that they can go into different ways light waves are associated with constantly like her to certain ways or
most people use the term light waves when they usually mean visible light in physics however these terms like veins are trying to be used as a synonym of electronic waves electric razor made of skull in magnetic and electric field like always they carry energy
Which of these are part of the electromagnetic spectrum?
Question options:
gamma rays
visible light
microwaves
sound waves
radio waves
Answer: A, C, E
Explanation:
Gamma rays, Microwaves, and Radio waves
_______ is the process which causes magma to form.
Answer:
flux melting
Explanation:
Flux melting is the process that causes magma to form. Flux melting happens when water or carbon dioxide exists added to rock.
What is meant by Flux melting?When rock is exposed to water or carbon dioxide, flux melting occurs. The rock melts at lower temperatures as a result of these substances. This causes magma to form where it had a solid structure before. Around subduction zones, flux melting also happens, much like heat transfer.
Flux melting happens in igneous petrology and volcanology when water and other volatile substances are added to hot solid rock, depressing the solidus. Flux is a material, such as salt, that produces a mixture with a metal oxide that has a low melting point (liquidus) in engineering and metallurgy.
To learn more about Flux melting, refer to:
https://brainly.com/question/24214679
#SPJ2
If the specific heat of iron = 0.46J C, how much heat is needed to warm 50 g of iron from 20C to 100C
Answer:
1840 J
Explanation:
From the question given above, the following data were obtained:
Specific heat capacity (C) = 0.46 J/gºC
Mass (M) = 50 g
Initial temperature (T₁) = 20 °C
Final temperature (T₂) = 100 °C
Heat (Q) required =?
Next, we shall determine the change in the temperature. This can be obtained as follow:
Initial temperature (T₁) = 20 °C
Final temperature (T₂) = 100 °C
Change in temperature (ΔT) =?
ΔT = T₂ – T₁
ΔT = 100 – 20
ΔT = 80 °C
Finally, we shall determine the heat required. This can be obtained as follow:
Specific heat capacity (C) = 0.46 J/gºC
Mass (M) = 50 g
Change in temperature (ΔT) = 80 °C
Heat (Q) required =?
Q = MCΔT
Q = 50 × 0.46 × 80
Q = 1840 J
Thus, 1840 J of heat energy is required.
Waldo needs to know how much force to apply in order to move a 4000-kg object at 2 m/S2. Which law should he refer to
A.
law of gravity
B.
second law
C.
third law
D.
first law
bebe xd mexico gana siempre
A bucket of water is pushed from left to
right with increasing speed across a horizontal
surface. Consider the pressure at two points
lat the same level in the water.
Answer:
It is higher at the point on the left
Explanation:
Which of the following shows the relationship between work and energy?
O A. Work = total energy
B. Work = gravitational potential energy
C. Work = change in kinetic energy
D. Work = change in nonconservative forces
What is this? Plz I need help...
Answer:
the time it takes for one complete back and forth swing
Explanation:
the Mark's is showing you the time it swings back and forth
Planet A has a tilt of five degrees. What seasonal changes would be expected on this planet? Extreme temperature changes between seasons Little to no change in temperatures between seasons Seasonal changes along the equator only Seasonal changes at the poles only
Answer:
Little to no change in temperatures between seasons.
Reason: because i got it right on the test, and i smart
Answer:
Little to no change in temperatures between seasons.
Explanation:
I can confirm this is right
The process of deforestation affects the different biochemical cycles on earth. Give three examples of how deforestation will affect the various cycles.
Answer:
The loss of trees and other vegetation can cause climate change, desertification, soil erosion, fewer crops, flooding, increased greenhouse gases in the atmosphere, and a host of problems for indigenous people.
What is inertia and how can you increase an object's inertia?
Answer:
Explanation:
Inertia is the property of a body by virtue of which it opposes any agency that attempts to put it in motion or, if it is moving, to change the magnitude or direction of its velocity.
The more mass, the more inertia. If you increase the mass of the object then you increase the inertia.
Answered by the ONE & ONLY #QUEEN
HOPED THIS HELPED!!
What is Heat engine?
Answer:
An engine made of heat!
Okay actual answer, A heat engine is a mechanical energy converter that transforms heat or thermal energy to mechanical energy.
Which of the following elements would you predict to have properties most like that of silicon, aluminum, phosphorous, or germanium?
If e is the electric field near an infinite sheet of charge and E is electric field between two similarly charged parallel plates then what will be the relation
Answer:
* the two plates of the same sign E = 0
* the two plates of different sign E/e = 2
Explanation:
In this exercise, the relationship between the field created by a plate and two infinite plates is asked.
The electric field created by each plate has the value of "e", which is related to the charge on the electric plate.
e = [tex]\frac{ \sigma }{2 \epsilon_o}[/tex]
If the plate is negative the electric field is directed towards the plate and if the plate is positive the electric field is directed out of the plate.
The test charge is always positive.
When we have two plates, we have several possibilities
* the two plates of the same sign
therefore the resulting electric field on the test charge is
E_total = e - e
E = 0
* the two plates of different sign
E_total = e + e
E = 2 e
the relationship between the two fields is
E/e = 2
Describe how the energy is transferred from the gas hob to cook the egg in the water.
Answer:
remember the ways in which the heat is transferred:
Conduction: Heat transfer of two objects touching.
Convection: Heat transfer in a medium with a gradient of temperature.
Radiation: Heat transferred between two objects that not touch each other (an example of this is how the Sun heats up the Earth)
First, we start with the gas itself.
It has a lot of pressure, so when you open the knob, the gas can get out.
The has chemical potential energy.
When you combust the gas, you transform that energy into heat energy, as the flame touches the pot, it starts o also heat the pot.
This heat energy is transferred to the pot, which transfers heat energy to the water by conduction, the heat in the water is "distributed" by convection, and as the water starts to heat up, the energy is transferred to the egg by conduction.
GIVING BRAINLIEST PLEASE HELP!!
-if you answer correctly ill give you brainliest which will give you 25pts-
Answer:
c
Explanation:
heat is thermal energy transferred from a hotter system while temperature is a measure of the average kinetic energy of atoms or molecules in the system
Eren Jagear supremacy? kind of.. rip? Eren Jagear supremacy? kind of.. rip?Eren Jagear supremacy? kind of.. rip?Eren Jagear supremacy? kind of.. rip?Eren Jagear supremacy? kind of.. rip?Eren Jagear supremacy? kind of.. rip?Eren Jagear supremacy? kind of.. rip?Eren Jagear supremacy? kind of.. rip?Eren Jagear supremacy? kind of.. rip?Eren Jagear supremacy? kind of.. rip?Eren Jagear supremacy? kind of.. rip?Eren Jagear supremacy? kind of.. rip?Eren Jagear supremacy? kind of.. rip?Eren Jagear supremacy? kind of.. rip?Eren Jagear supremacy? kind of.. rip?
sis i love the eren season 1-2-3-4 but the eren season 5?....... i just :')
Answer:
Explanation:
Aaron yogurt supremacy
Which color has the lowest frequency?
A typical electromagnetic signal from a communications satellite might have an intensity of 0.600 pW/m2 at the surface of the Earth. Your satellite dish collects the energy of the electromagnetic signal from the satellite; then your dish passes that energy to its central receiver, where the signal can be processed by a circuit. The area of a satellite dish can be calculated from pi (3.1416) times the radius squared. If your satellite dish has a radius of 0.28 m, and if it is receiving the signal described above, how much electromagnetic energy is reflected to the central receiver in 2.5 minutes
Answer:
The answer is "22.05 pJ"
Explanation:
Using formula:
[tex]Energy=power\times time\\\\Power=Intensity \times area[/tex]
Calculating Energy:
[tex]=0.147 \times 2.5 \times 60 \times 10^{-12}\\\\=22.05\ pJ[/tex]
As a light wave strikes a shiny surface like a piece of polished metal, it will be
refracted
reflected
absorbed
Please help!!!!!
The thermal transfer of energy through a copper rod involves electrons. A second process is also involved.
Answer:
hello your question is incomplete attached below is the complete question
answer : Conduction, Lattice vibration ( B )
Explanation:
The thermal transfer of energy occurs in a solid like a copper rod following two process therefore the second process and method are
Lattice vibration and conduction
Lattice vibration is the movement/oscillation of atoms in a solid and this is caused by the change/increase in temperature applied to the solid and these vibrations will lead to the thermal transfer of energy via conduction since the atoms are bounded together .
Dani says, "This classroom is 11 meters long. A meter is longer than a yard, so if I measure the length of this classroom in yards, I will get less than 11 yards."
Do you agree with Dani ?
Answer:
im not sure i just need points....
Explanation:
Describe how Newton's 1st Law of Motion is used on a daily basis at school.
how to calculate acceleration
Answer:
Acceleration (a) is the change in velocity (Δv) over the change in time (Δt), represented by the equation a = Δv/Δt. This allows you to measure how fast velocity changes in meters per second squared (m/s^2). Acceleration is also a vector quantity, so it includes both magnitude and direction.
Explanation:
hope it help mark me as brill please
Answer:
acceleration equals the change in velocity divided by time
Explanation:
What will be the change of velocity of a 50kg object if a force of 2,000N
is applied to it for 0.010 seconds?
Answer:
0.4m/s
Explanation:
[tex]F = ma[/tex] where F= force, m= mass, and a=acceleration
we also know that,
a = Δv / t where Δv = change in velocity and t = time
thus F = m ( Δv / t)
[tex]2000=50(\frac{v}{0.01})[/tex]
[tex]\frac{2000}{5000} = v[/tex]
0.4m/s = Δv